Crystal-field engineering of ultrabroadband mid-infrared emission in Co2+-doped nano-chalcogenide glass composites

Tunable and ultrabroadband mid-infrared (MIR) emissions in the range of 2.5–4.5 μm are firstly reported from Co²⁺-doped nano-chalcogenide (ChG) glass composites. The composites embedded with a variety of binary (ZnS, CdS, ZnSe) and ternary (ZnCdS, ZnSSe) ChG nanocrystals (NCs) can be readily obtained by a simple one-step thermal annealing method. They are highly transparent in the near- and mid-infrared wavelength region. Low-cost and commercially available Er³⁺-doped fiber lasers can be used as the excitation source. By crystal-field engineering of the embedded NCs through cation- or anion-substitution, the emission properties of Co²⁺ including its emission peak wavelength and bandwidth can be tailored in a broad spectral range. The phenomena can be accounted for by crystal-field theory. Such nano-ChG composites, perfectly filling the 3–4 μm spectral gap between the oscillations of Cr²⁺ and Fe²⁺ doped IIVI ChG crystals, may find important MIR photonic applications (e.g., gas sensing), or can be used directly as an efficient pump source for Fe²⁺: IIVI crystals which are suffering from lack of pump sources.     

郴州某复杂硫化铅锌矿阶段磨浮试验研究

针对郴州某复杂硫化铅锌矿资源的性质特点,采用铅快速浮选后尾矿再磨再选的阶磨阶选工艺,较好地实现了铅锌的高效浮选回收。研究了磨矿方式、捕收剂和调整剂种类及用量等因素对该矿石浮选的影响,确定了最佳浮选条件,通过小型闭路浮选试验,得到了铅品位60.05%、回收率89.63%的铅精矿和锌品位47.01%、回收率88.14%的锌精矿。     

托盘式湿法烟气脱硫塔阻力特性研究

采用冷态物理模型结合商用CFD(Computational Fluid Dynamics)软件,对山东某火电厂300 MW机组配套托盘塔的流场和阻力特性进行了研究,取得了孔板阻力损失与液气比之间的二次函数关系。研究结果表明,塔内两相流场分布合理,入口处液滴受烟气的拖拽作用形成明显的干湿界面,负荷和液气比是影响脱硫塔阻力的重要因素。当液气比一定时,托盘上方能够维持相对稳定的持液层及鼓泡过程;满负荷运行时,脱硫塔阻力损失约为1600 Pa,其中孔板占1/4,持液层占3/4。拟合获得了托盘区阻力损失同液气比之间的关系,为托盘塔的应用、运行及优化提供了理论指导。     

电场对竖直矩形微槽群润湿及表面温度的影响

微槽群在热流密度较大时会达到其毛细极限，可通过主动换热方式之一——电水动力学效应对其进行强化。本文为了研究电场对微槽群表面润湿特性和温度分布的影响，采用平板电极提供电场，蒸馏水作为工质，使用高速相机拍摄微槽内液体润湿长度，测量误差为2.97%～7.46%；使用红外热像仪拍摄电场作用下微槽群表面温度分布，测量误差为2.1%～2.39%。热流密度测量误差范围是9.66%～11.11%。结果表明：电场通过驱动微槽内流体向加热区域流动而提升其润湿性能，且较低热流密度下提升更好。因润湿性能的提升，微槽表面温度得以下降。随着电场增强，微槽横向温度分布的“波峰”、“波谷”差别加大，微槽纵向温度明显降低。当热流密度加大时，温降更为显著，1.4W/cm²热流密度、6kV电压下温降可达到30℃以上。温降的增加反映了电场对微槽的强化润湿进一步提升了微槽换热性能，且电场对较高热流情形下的微槽换热有着更为显著的强化效果。     

高落差粉尘扩散规律和分布特征

高溜井放矿过程中会形成强大的冲击气流引起粉尘扩散，造成严重的井下环境污染，对其进行有效治理一直是井下通风除尘的工作重心，本工作利用相似实验和数值模拟相结合的方式探究溜井放矿过程中粉尘的扩散规律和分布特征。通过改变放矿质量、矿石粒径、溜井密闭程度、含水率等因素测试不同条件下气流大小和粉尘浓度分布，并利用CFD-DPM耦合方法模拟卸矿过程中的气?固两相流，研究气流和粉尘浓度时空分布特征。结果表明，最大粉尘浓度和风速随放矿质量增加而上升，随颗粒粒径和溜井密闭程度增大而降低，且含水率越大，粉尘浓度越小，风速无明显变化，在放矿过程中矿石颗粒之间碰撞占主导作用，颗粒流呈横向分布。     

矿用无人卡车国内外研究现状及关键技术

分析了国内外露天矿山用卡车无人驾驶技术发展现状,详细介绍了露天矿山卡车无人驾驶关键技术;通过分析对比前装线控和后装线控两种技术路线的优缺点以及超声波雷达、毫米波雷达、激光雷达、4D光场智能感知系统、红外传感器、视觉传感器等环境感知技术的优缺点;提出多传感器高度融合将是露天矿山卡车实现全天候环境感知的发展方向。通过分析对比惯性导航系统、GNSS差分定位技术、车联网定位技术、电子地图定位技术、视觉传感器等定位导航技术的差异,指出多定位技术融合是露天矿山无人驾驶卡车定位方式的必然选择。结合露天煤矿的生产实际,提出将现有的无人驾驶各种技术算法与露天矿山标准作业流程有机融合是实现卡车无人驾驶的必由之路。最后指出无人驾驶卡车应用5G技术是露天矿山安全生产的关键和核心,是无人驾驶的必备技术。     

The effects of electrical comminution on the mineral liberation and surface chemistry of a porphyry copper ore

The surface chemistry and mineral liberation changes of a porphyry copper ore after high voltage pulse (HVP) electrical comminution have been investigated using X-ray photoelectron spectroscopy (XPS) and mineral liberation analysis (MLA). Previous studies suggest that electrical comminution has the potential to improve downstream flotation recoveries, due to increased mineral liberation. However, until now the effects on the surface chemistry have not been investigated in detail.The mineral liberation results showed that chalcopyrite was more liberated in the electrical comminution product than in mechanical comminution, noticeably in the coarser size fractions. The surface chemistry of pure chalcopyrite was investigated, using XPS, and high resolution scans of iron and sulphur showed that both comminution methods led to iron oxidising preferentially leaving behind a passivating film of copper sulphides. However, the HVP product oxidisation was more severe with more iron oxide being produced and further oxidation of the remaining copper sulphides into copper sulphate. An attrition grinding stage may be useful in removing the oxidised layer from the surface of the particles prior to flotation separation. This paper presents a new application of the HVP technology in hybrid procedures using electrical comminution and mechanical grinding to prepare the flotation feed, rather than using excessive pulse energy to fully disintegrate ore to the flotation size. Better liberation and flotation performance were achieved through the hybrid procedures than the comparative mechanical comminution.     

湿式摩擦副滑摩过程温度场分析及实验验证

湿式摩擦副滑摩过程温度场与应力场相互耦合作用,温度场分布受到多种因素影响,其中压力、旋转速度、润滑流量作为湿式摩擦副工作参数对其温度场的影响尤为显著。在理论分析基础上,采用有限元数值模拟分析与实验研究相结合的方法,对摩擦界面温度场时空分布特性进行研究,同时研究界面温度场在摩擦副工作压力、相对转速和润滑流量作用下的变化规律。研究表明:在对偶钢片和摩擦片近外径侧更易出现高温和应力集中区,且对偶钢片相对于摩擦片更易出现温度和应力分布不均匀情况;温度场中高温集中区与应力场中应力集中区相对应,最大温度随着压力增加、相对转速增大、润滑流量减少而显著上升,该结果得到试验结果的验证。     

某含锌锡多金属硫化矿石锌浮选试验研究

某含锌锡多金属硫化矿石Zn、Sn、Fe、S含量分别为6.04%、1.05%、29.33%、19.08%，锌主要以铁闪锌矿、闪锌矿的形式存在，锡主要以锡石的形式存在，铁主要以黄铁矿、磁黄铁矿等形式存在，其中的金属矿物共生关系密切，相互包裹现象普遍。为确保不影响后续选锡，对锌浮选流程进行了试验研究。结果表明：矿石在磨矿细度为-0.074 mm占80%的情况下，采用预先脱硫—锌硫混浮再分离流程处理，在选择硫酸铜为锌矿物活化剂、丁基黄药为捕收剂、松醇油为起泡剂、石灰为黄铁矿抑制剂的情况下，经1段脱硫、2粗1扫锌硫混浮、1粗2精锌硫分离，锌硫分离精选尾矿与锌硫混浮扫选精矿2次精选后锌硫分离，最终获得锌精矿Zn品位47.06%、回收率90.76%，试验指标良好。